Pearson Boats - Common Systems > Electrical Systems & Electronics

Shorepower inlet.

<< < (3/3)

jmcmonagle:
It's rather challenging to trace the routing of the wire from the inlet to the fuses.
From what I can tell it goes down from the inlet, Goes under the cockpit sole and goes forward  a few inches in along the starboard side.
Then it follows the bullhead to the fuses.
From my measurements it's under 10' to the fuses and  a couple feet shorter to the new panel.

So far have removed old switch and outlet and have cut in new outlet box and hole for panel.
Temporarily removed manual bilge pump to improve access from back.
Really challenging cutting some of the cable ties.
They must have put them in when the boat was only partially assembled.

Have traced out all the ac wires other then neutral and ground for water heater.
Hope they will be more obvious after pulling the other wires from the old ac panel.

Should be able to move wires to new panel soon.
Attached is photo of new panel.
It's not screwed in so it's a little low in the hole.

Navigation

[0] Message Index

[*] Previous page