Messages

1

Electrical Systems & Electronics / Re: In mast wires

« on: May 17, 2014, 06:13:00 PM »

Thanks Rusty P. for the reply. Have you used a wire snake on your mast wiring?

Would you recommend sending the snake down and pulling a messenger line back up to pull the new wire down?

Where do I need to go to place our boat on the owners listing?

Thanks again,

Bob

2

Electrical Systems & Electronics / In mast wires

« on: May 16, 2014, 10:05:35 PM »

Hello all,

I'm a newer member that just purchased Hull# 369. This is our second time around with a P323. We previously owned Hull# 361 during the late 1990s. We came back to the P323 because we believe it was the best boat we had owned. We are happy to have that stout hull under us again. We are naming the new boat "Deja vu" for obvious reasons.

My question is about running a wind instrument wire down the inside of the mast. This boat, and our previous one, has never had an electronic wind instrument installed. Can anyone offer insight into getting the wire down to the mast step?

Thanks for your help.

Bob Sardo