Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - chuck stas

Pages: [1]
1
New Member Introductions / Re: Dyneema or other synthetic standing rigging
« on: September 05, 2022, 11:45:32 AM »
how did you make out with the rigging ??

2
New Member Introductions / Re: New Member
« on: July 31, 2022, 10:49:11 AM »
Welcome,  not much activity on the site but every time I asked a question its been answered.
Good luck enjoy.

3
Engine and Drive Train / Re: Losing antifreeze
« on: June 18, 2022, 11:43:36 AM »
maybe just low to start.
hopefully

4
Engine and Drive Train / Re: engine shakes
« on: June 11, 2022, 10:39:13 AM »
Thanks for the input. It shakes a lot. But then stops and runs smooth. I don't think its the engine that runs smooth. Can't figure why it just stops shaking than runs OK.
Wish I could help you with why yours is not behaving at 2000-2500 RPM. If I hear of something I'll let you know.

5
Engine and Drive Train / Re: engine shakes
« on: June 10, 2022, 11:42:07 AM »
I'll take a look,  not sure how old they are.
Whats the best way to check them ?

6
Engine and Drive Train / engine shakes
« on: June 09, 2022, 09:32:47 AM »
Good Morning, Does anyone have or had this problem ?
I have a 1983 P303 with a yamar 13hp diesel. When I start it [ Starts easy ] It run great. When I put it in gear the engine shakes a lot, than when I bring the RPM's up it stops. At 1st I through there was something stuck on the prop. When it stops I'm good to go went 14 hours with no problem.
Cutlass bearing was tight. When I checked it before it was put back in the water.
Any ideas of what I should look at.
Thanks for any help

7
Engine and Drive Train / Re: Pearson 303 Stern Tube
« on: May 07, 2022, 10:13:54 AM »
did you get the answer you needed ?

8
General Discussion / Re: mast foot bracket.
« on: April 14, 2022, 08:44:20 AM »
Thanks for the info I'll look the up.

9
General Discussion / mast foot bracket.
« on: April 12, 2022, 09:53:08 AM »
Good Morning, I'm trying to get some info on a part for a 1983 p303
At the bottom of the mast there's a bracket holding the mast onto the keel in the bilge area.  it seems rusted, anyone know it I can buy the replacement part or do I need to have it made ??
any info would help.

10
P303 / Re: OEM Anchor light Replacement Bulb
« on: April 09, 2022, 10:55:43 AM »
i do not but led would be best replacement

11
P303 / Re: rudder packing
« on: April 09, 2022, 10:54:42 AM »
any luck with the rudder ?
do you have any pictures ?

12
P303 / Re: 303 cutless bearing replace
« on: April 09, 2022, 10:53:28 AM »
any luck getting that bearing out ??

Pages: [1]