Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - BlueLagoon

Pages: [1]
1
Interior Structures / Re: Salon deck
« on: September 16, 2021, 05:25:50 PM »
That is correct, mine is the same way.  I stand on the fuel tank and lift the deck straight up.   Not sure what wiring harness you are looking for, for example the Mast wiring.  On my, hull #3, it runs on the Stb side some along the water tank and some under the benches. Also there is a bunch of wiring in the overhead above the benches.   Hope this helps.

2
Plumbing and Galley Systems / Re: Idea's for a new fridge.
« on: March 02, 2021, 12:06:54 AM »
Not sure if this issue is dead or not but i can chime in on my ice box to fridge and freezer journey.   I first tried cutting 2 inch holes on 6 in centers.  I used a two part spray foam similar to this product.  https://tigerfoam.com/sprayfoaminsulation/order-products/spray-foam-kits/tf-200fr-tiger-foam-fast-rise-200-board-ft-kit/.  Once the foam is dried you need to recess the foam so the cut circles will fit back in place for fiber glassing.  That work well for about 2 years.  I am 6' 4'' and my wife is 5' 3'' so she look like a dumpster diver every time she need something.  Also our compressor needed replacing so with those two facts, I converted by top load to side by side units.   On think I noticed when I removed the old ice box was the spray foam did not fill the void like I expected it to. Also the spray foam curried in balls instead of a flat surface.  i am guessing it due the way I sprayed the material.   I decided to go with VIP insulated panels and two Sea Frost compressors and holding plates.   RParts built the panel boxes and door frames.  I assembled and out the box in place.   not sure if this help any.... cheers.

3
I am in the process of installing my refrig and freezer.  I decided to go with VIP insulation panels and two sea frost compressors.   I worked with a company called RParts on the design and assembly of the VIP Panels.  They work with a VIP manufacture and then skin the panels with fiber board so you can glue and paint the them. 


4
Blue Lagoon is a Pearson 530 hull #3 home ported in San Diego CA.  I am currently in a major refit getting ready for our Nov 2022 around the world adventure.   Look forward in participating in the various forum topics.

Chees,

Charles Shelby

Pages: [1]