Pearson Yachts Forum

Pearson Boats - Model Specific Discussion => Pearson Sailboats 26-30ft => P303 => Topic started by: JohnnyD on December 30, 2021, 10:00:27 AM

Title: 303 cutless bearing replace
Post by: JohnnyD on December 30, 2021, 10:00:27 AM

Has anyone with a 303 or similar design shaft log replaced the cutless bearing. Any problems to look for, does the shaft have to be pulled?

Title: Re: 303 cutless bearing replace
Post by: chuck stas on April 09, 2022, 10:53:28 AM

any luck getting that bearing out ??

Title: Re: 303 cutless bearing replace
Post by: chuck stas on November 09, 2022, 09:46:06 AM

did you ever get the bearing replaced ?

Title: Re: 303 cutless bearing replace
Post by: StarGazerII on February 13, 2023, 12:53:22 AM

If you still need info contact me thanks! Capt. Rob
The bearing should be part name "BAIL" and yes remove the shaft first and the cutlass bearing with a hose. Get a pipe 3/8 inch. larger than the "Shaft" but not more than the dia of outside the bearing. use this pipe to knock out the old bearing from the inside if needed. The bearing has two set-screws 1 on each side L & R of the opening.
Install your new bearing and insert the shaft with the prop. reconnect inside cutless and boot.  Note:  I install a set-caller before connecting back to the coupler. to prevent the shaft and prop from leaving or pulling out all the way!
Hope this helps!
Capt. Rob
Update: saw my box and the part number is "BAIL" and not BEAR..