2
« on: September 01, 2021, 11:30:06 AM »
Just joined the group we purchased our 1976 p35 2 yrs ago. The Summit is very clean but needed a repower .with at complete we are lnow ooking to add some creature comforts first is the icebox conversion. I made a template for a tray which I made a stainless steel pan .Since cold falls to the lowest point and the icebox is extremely deep i created it for about 16 " off of the bottom. Below that i plan on pouring in 2prt expandable foam then bedding the stainless tray into the foam. I will then add 2-3" of foil backed ridgid foam on the sides above the tray . Finish by installing an isotherm o shaped cold plate. Only have welded the tray so far. I thought we could potentially make ice in the o shaped cooler. Any suggestions before I go any further?