Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - Frayed Knot

Pages: [1] 2 3 ... 9
General Discussion / Re: Builder's Plate
« on: June 20, 2022, 07:00:48 PM »  Ed that is where I purchased it from and it was $100.00.  It took about two week's .  I found it on this site under general on the second page.  Hope your doing well.

General Discussion / Builder's Plate
« on: June 17, 2022, 05:10:08 PM »
It looks better in person.  I love it, you have to get one.  I think I am going to paint the background the same color of my hull (Dark blue).  I will let you know how it turns out.  Painted today...

General Discussion / Re: Post Video
« on: May 19, 2021, 08:24:07 PM »
Thank You,
 that worked...

Cruising / NC to SC
« on: March 01, 2021, 05:53:10 PM »
Coming home from Stede Bonnet Race in Southport, NC.  6 hour trip in 4... Watch the video I think you will like it.  Leave a reply      Also came in second this year   Woop Woop...

General Discussion / Post Video
« on: February 13, 2021, 11:07:56 AM »
If I wanted to post a short video of sailing, how do I go about it.  Every time I try to do it the whole post goes away.  I even tried to shorten the video  but no help. 

Engine and Drive Train / Re: V-Drive question
« on: December 08, 2020, 10:11:24 PM »
Mine has a 23HP 2-cylinder Volvo MD 11C Diesel Engine and 1.91:1 reduction gear in V-drive.

New Member Introductions / Re: New Owner P323 "Sea Fever"in NC
« on: July 29, 2020, 03:35:06 PM »
You are going to love your 323.  Welcome...

Cruising / Pirate Race 2019
« on: November 08, 2019, 06:32:02 PM »
Second Place... Don't know how we did it, But we did.

Exterior Finish and Fiberglass / ALL CLEAN BOTTOM
« on: October 01, 2019, 04:30:48 PM »
Sure look's big from the outside.

Sails and Canvas / Re: waterproofing bimini
« on: August 25, 2018, 10:29:48 AM »
A little late but the 303 is the best $$$

P40 / Pearson 40
« on: August 16, 2018, 06:26:43 PM »
I was looking and thinking about a Pearson 40 with a flush deck.  What are your thoughts about this vessel.  At the price I have seen I might just be dreaming.  It look's fast just sitting at the dock.

Standing & Running Rigging and Fitting/Tuning / Re: Boom Vang
« on: May 04, 2018, 10:35:35 AM »
The bottom of the Vang should be as low as possible on the mast and the Vang should be 30 to not more than 45 degrees of an angle.  I am not an expert, but that is what I understand where it should be.  Make a mark at the attachment point on the mast and use a degree wheel to to figure the angle and mark the boom.  Measure between the two marks and that should be the length.  NOTE (the angle should be made from the boom)

Standing & Running Rigging and Fitting/Tuning / Boom Vang
« on: May 01, 2018, 09:55:00 PM »
Just got a killer deal on a Boom Vang.  Want to know what type of attachment points should I get?  Like the boom should I just get a one bolt boom bail and what size?  Also the mast, should I get something that will move to both sides or a mast hound.  It is a soft Vang.  Don't want to spend a lot but would like something descent, is that possible?   I will be installing this myself.  Thank You for the input.   Dick

General Discussion / Re: INSURANCE
« on: February 16, 2018, 02:17:42 PM »
I have Progressive and is under $400.00 a year.  Covers 35,000.00.

Cruising / Re: Coming Soon
« on: January 13, 2018, 12:53:09 PM »
rnebergall Nice picture.  Looks like a fun sail, all reefed up.

Pages: [1] 2 3 ... 9