1
Engine and Drive Train / 2GM20F water
« on: July 18, 2020, 08:10:20 AM »
Hi, I had the clamp on the outlet hose of the impeller fail and the hose fell off. The clamp was replaced and the impeller housing opened and checked (all looked fine).
But now when I start the engine I can hear water in exhaust but no water is coming out of the exhaust.
This was working fine prior to the hose clamp failure.
Any thoughts on this?
But now when I start the engine I can hear water in exhaust but no water is coming out of the exhaust.
This was working fine prior to the hose clamp failure.
Any thoughts on this?