Pearson Boats - Common Systems > Deck Mounted Hardware

primary winch lead and other issues.

(1/2) > >>

jmcmonagle:
My only cockpit winches are in the usual primary position in the front of the cockpit.
Have a few issues:
With the 150% jenny the lead is near the aft stanchion.
The lead is too low.
Much of the time when I move the car need to re-route the sheet.
The sheet goes through part of the dodger so I need to leave it partially unsnapped when sailing.
The winch handle also hits the dodger strap and the dodger if it was not unsnapped.

See 2 solutions:
1. Move winches back to about where a secondary winch would be.
From there could trim while at helm.
Lead wouldn't be perfect but much better.
Would have to fix holes or possibly put in a secondary winches in that spot.

2. Put in turning blocks,
Redo dodger to get rid of strap.
Trim dodger a little to clear handle. Will not take much.

Any thought thoughts on this?
Any other way to fix it?

John
 

rnebergall:
Dodger is not installed in this pic, but you can see the attachment points forward of the primary winch.  As you can see, the sheet runs outboard from the lead block, to a turning block.  Sheet comes inboard aft of the aft-most lifeline stanchion.  No interference with dodger when it is in place.  Is a turning block such as I have here what you are thinking about?

Granted, the head-sail here is 130, but this rig worked fine when I did have and use a 155% and had the lead block further aft.

Sorry if I just don't seem to understand the problem.

jmcmonagle:
Yes that is one of the fixes I'm considering.
Looks good.
My dodger problems are fixable but who ever designed the dodger was not thinking about sailing.

Rusty Pelican:
I had the pleasure of meeting the canvas guy for Pearson and Bristol Yachts.
The boats were designed without the slightest concern for a dodger.
Dodgers were rare back then. Custom and expensive.

Bill1188:
In the photo, the turning block used is where I usually run my asymmetrical sheet. Using the set up depicted here, how do you rig your spinaker sheet?

Navigation

[0] Message Index

[#] Next page