Pearson Boats - Common Systems > Deck Mounted Hardware
Deck fill O-rings
Dolce_Vita:
On the P323, all 5 deck fills (3 water, 1 waste, 1 fuel) seem to be the same size. Anyone know what size o-ring they take?
m_boone:
I looked at the Pearson 323 parts list but no luck there. The next time I'm at the marina I'll measure them though.
Dolce_Vita:
I've since gotten to the boat and measured them. I ordered a bag of the closest standard size I could find on McMaster-Carr, and we'll see how they fit. Will report back.
Rusty Pelican:
I had a similar situation, I dropped a deck fill cover overboard
My deck fills are Wilcock & Crittenden.
Eventually I found out that W & C have proprietary threads, very hard to find.
I did find one at a salvage yard
Dolce_Vita:
I ordered a pack of Oil-Resistant Soft Buna-N O-Rings, 3/32 Fractional Width, Dash Number 132. Part number 2418T151.
These have an ID of 1.737" and a thickness of 0.103". Less than $10 for a pack of 20, but shipping is another $8!
These seemed to fit ok, but might be a little loose. Probably should have gone down one size for a stretch-tight fit.
Navigation
[0] Message Index
[#] Next page
Go to full version