Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - rnebergall

Pages: [1]
1
Hello all.  Wanting to replace the non-working, original (on Zufrieden in 1992 when I bought her) dual action foot pump.  In my case, this pump serves as backup to the pressure system, in the galley.  The picture below shows the installation, near the hull, just forward of the ice-box.  The pump is attached, by it's base, to the horizontal piece of plywood shown in the picture.  I have managed to get the two out-board screws out, but cannot see how I can get to the two screws near the vertical piece of plywood, without removing the entire plywood structure, on which the pump is mounted.  In order to remove the plywood mounting pieces, I would have to cut the fiberglass strip that provides a tie-in to the hull.  If that's what I need to do..fine, but I'm wondering if others have encountered this and if so, how did you get the pump out?  Thanks.

Roger Nebergall (Zufrieden)

Pages: [1]